Clean energy and climate

UrbanSentinel treats water without grid electricity, without added chemicals, and with salvaged parts wherever they will do. In a country whose biggest export is washed in its rivers and whose grid runs almost entirely on fossil fuels, that is the point of the design, not a side benefit.

Why energy is part of the water problem

Conventional treatment needs reliable grid power, a steady supply of chemicals and new equipment. In Bangladesh, all three are hardest to find exactly where the water is worst.

98%

of Bangladesh's electricity comes from fossil fuels. Renewables supplied about 2.3% of grid generation.

Ember; IEEFA (2026)
5.6 million

people were affected by the August 2024 floods in eastern Bangladesh. Floods often cut the power when water is most contaminated.

UNICEF (2024)
170–600 kt

of e-waste a year in Bangladesh, mostly handled informally, with only seven registered recyclers.

Transparency International Bangladesh (2025)

Four design choices

The portable plasma purifier. A complete treatment unit that fits in one hand: a small solar panel charges recovered lithium cells, and a flyback transformer from a scrapped CRT television drives the plasma electrode. No grid connection and no chemicals.

1. Solar power instead of the grid

A solar panel charges a 12–18 V battery pack assembled from recovered laptop and phone cells. A zero-voltage-switching driver steps that up to 10–12 kV at the electrode, with a peak of 55 W. Nothing connects to the grid, so the unit keeps working in a flood, at a remote outfall or on a coastal embankment. Built

2. Circular hardware from electronic waste

The plasma driver is built almost entirely from salvaged parts. Its first version, the 2024 Stockholm Junior Water Prize Bangladesh winner, cost about US$5 in parts, according to the Stockholm Water Foundation project page. Built

PartSalvaged fromRole in UrbanSentinel
N-channel MOSFETsScrapped auto-rickshaw motor-driver boardsHigh-frequency switching in the plasma driver
Flyback transformerDiscarded CRT televisionsSteps 12–18 V up to 10–12 kV
Lithium-ion cellsEnd-of-life laptop and phone batteries12–18 V solar-charged battery pack
Carbon electrodesSpent zinc–carbon dry cellsElectrodes for the plasma discharge
Resistors, inductors, diodesSalvaged TV, UPS and inverter boardsDriver and tuning circuit
LEDs, laser, photodiode, CCD sensorOld electronicsOptics of the testing module
Where the parts come from. From scrap to reactor: MOSFETs from abandoned auto-rickshaw motor drivers, high-voltage transformers from old CRT televisions and their circuit boards, lithium cells from dead laptop and phone batteries, and spare parts, assembled into the high-voltage plasma purifier.
Flyback transformers from old televisions. High-voltage flyback transformers recovered from discarded CRT televisions. Each one is tested and reused as the step-up stage of a plasma reactor.
Salvaged power transistors. N-channel MOSFETs recovered from scrapped auto-rickshaw motor-driver boards, sorted before they go into the plasma driver. Components like these normally end up in informal scrap yards.

3. Chemistry made in the water, not added to it

The discharge sits about 2 cm above the water, with the second electrode immersed. It forms hydroxyl radicals, ozone, hydrogen peroxide, reactive nitrogen species and ultraviolet light at the water's surface. These break apart azo dyes and inactivate bacteria. No chlorine, coagulants or other reagents are added, so there is no chemical sludge to dispose of.

The treatment is non-thermal: over a 30-minute run at 55 W, the bulk water warmed by just 2.9 °C. Measured

Air plasma does acidify water slightly (pH 7.2 to 6.4 in tests), so pilot units restore pH with aeration and limestone and check nitrate and nitrite on every batch.

How plasma cleans water. Reactive oxygen and nitrogen species formed at the gas–liquid interface cleave azo dyes and inactivate microbes.Illustration made with Gemini Notebook

4. Only the energy the water needs

Without a fast test, an operator must dose every batch as if it were the worst case. UrbanSentinel re-tests in seconds, so it can stop the moment the water passes. On one reactor, the energy needed ranges about 500-fold between a disinfection pulse and a dye cycle, which is where the saving comes from.

The energy math

Energy is power multiplied by time. At a constant 55 W, the three measured treatment cycles use very different amounts.

E = P × t

Disinfection: 55 W × 3 s = 0.046 Wh
BOD and COD: 55 W × 15 min = 13.75 Wh
Textile dye: 55 W × 25 min = 22.9 Wh

Mean energy per batch, where f is the share of each kind of event:
Ē = f₁E₁ + f₂E₂ + f₃E₃

Saving against worst-case dosing:
1 − Ē ÷ 22.9 Wh

Energy per treatment cycle

Watt-hours, measured cycles at a constant 55 W. A dye cycle uses about 500 times the energy of a disinfection pulse.

0510152025Disinfection55 W × 3 s0.046 Whtoo small to see at this scaleBOD and COD55 W × 15 min13.75 WhTextile dye55 W × 25 min22.9 Wh
Show the data as a table
CyclePower × timeEnergy (Wh)
Disinfection55 W × 3 s0.046
BOD and COD55 W × 15 min13.75
Textile dye55 W × 25 min22.9

Try the energy model

Set the mix of events a unit handles. Shares always add up to 100%.

Mean energy per batch

5.1Wh

0.70 × 0.046 + 0.20 × 13.75 + 0.10 × 22.9 = 5.1 Wh

78% less than dosing every batch for the worst case (22.9 Wh).

Worst-case dose22.9 Wh
This mix5.1 Wh

Modelled Savings are modelled from the measured cycles. The Phase 1 pilot will measure the real mix of events.

Where UrbanSentinel meets the Sustainable Development Goals

Eight goals, each tied to a specific UN target and to evidence from the project. The label on each row says how far that evidence goes.

  • SDG 6: Clean water and sanitation

    • 6.3 Improve water quality by reducing pollution and halving untreated wastewater
    • 6.1 Safe and affordable drinking water for all

    Disinfects in seconds (total coliform 226 → 0 per 100 mL) and polishes textile effluent before it reaches rivers. The Pond Sand Filter add-on targets drinking water on the coast.

    Measured
  • SDG 7: Affordable and clean energy

    • 7.2 Increase the share of renewable energy
    • 7.3 Improve energy efficiency

    Runs on a solar-charged 12–18 V battery instead of a grid that is about 98% fossil-fuelled, and stops at compliance instead of dosing for the worst case.

    Modelled
  • SDG 12: Responsible consumption and production

    • 12.4 Sound management of chemicals and wastes, reducing releases to water and soil
    • 12.5 Reduce waste through reuse and recycling

    Reuses transistors, transformers, lithium cells and electrodes from e-waste, adds no treatment chemicals, and gives textile supply chains a batch-by-batch discharge record.

    Built
  • SDG 13: Climate action

    • 13.1 Strengthen resilience to climate-related hazards and natural disasters

    Works off-grid when floods and cyclones cut the power. An earlier portable unit served about 170 families in Feni during the August 2024 floods.

    Field use, 2024
  • SDG 3: Good health and well-being

    • 3.9 Reduce illness from water pollution and hazardous chemicals
    • 3.3 End epidemics of water-borne diseases

    E. coli was found in the drinking water of 81.9% of Bangladeshi households in 2019, against 40.3% at the source. Plasma removed all detectable E. coli (93 to 0 per 100 mL) in 2–3 seconds.

    Measured
  • SDG 9: Industry, innovation and infrastructure

    • 9.4 Retrofit industries with clean and environmentally sound technologies

    Designed as an add-on stage for the effluent plants factories already have, rather than a replacement for them.

    Designed
  • SDG 11: Sustainable cities and communities

    • 11.6 Reduce the adverse environmental impact of cities

    A network of units at outfalls and water intakes is designed to flag discharges and warn intakes 2–6 hours ahead (Phase 2).

    Designed
  • SDG 14: Life below water, and 15: Life on land

    • 14.1 Reduce pollution from land-based activities
    • 15.1 Conserve freshwater ecosystems

    The Phase 1 pilot is modelled to keep 0.6–1.8 million m³ of untreated effluent a year out of the Turag, and salvaged electronics stay out of soil and water.

    Modelled

Target wording paraphrased from the UN Sustainable Development Goals. Household E. coli figure: BBS and UNICEF, MICS 2019 water quality report.

What the project does not claim yet

Credible climate claims need numbers behind them. These are the gaps the pilot is designed to close.

  • No carbon figure yet. The device runs on solar power, but the embodied footprint of the panel, enclosure and refurbishment has not been assessed.
  • Energy savings are modelled. They come from measured cycles; the real mix of events will be measured in Phase 1.
  • A polishing stage, not a full plant. BOD (7 mg/L against a 5 mg/L limit) and pH missed their limits, so the reactor complements biological treatment rather than replacing it.
  • PFAS removal, not destruction. One test lowered PFOA and PFOS; the repeat will add a no-plasma control, a short-chain PFAS panel and a fluoride measurement.

Sources

  1. Ember, Bangladesh electricity data
  2. IEEFA (2026), Fostering Bangladesh's energy transition
  3. UNICEF (2024), floods in eastern Bangladesh
  4. Transparency International Bangladesh (2025), e-waste management
  5. Stockholm Water Foundation, High Voltage Plasma Water Purifier from E-Waste (2024)
  6. BBS and UNICEF (2019), MICS water quality thematic report
  7. Measured values: UrbanSentinel campaign logs at BUET's water quality laboratory and the BEXIMCO effluent treatment plant